Home/Support/Support Forum/DigiConnect core 8x first install problem
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

DigiConnect core 8x first install problem

0 votes
Hello
I have ConnectCore 8x SOM install on my board. I would like install linux os but I have error, see below:
<code>
U-Boot dub-2019.04-r2.1 (Jun 16 2020 - 08:24:59 +0200)

CPU: NXP i.MX8QXP RevC A35 at 1200 MHz at 54C
DRAM: 2 GiB
MCA: HW_VER=1 FW_VER=0.18
MMC: FSL_SDHC: 0, FSL_SDHC: 1
In: serial
Out: serial
Err: serial
Model: Digi International ConnectCore 8X SBC Pro Board.
ConnectCore 8X SOM variant 0x02: 2 GiB LPDDR4, Wi-Fi, Bluetooth, MCA, Crypto-auth
Board version undefined, ID undefined
Boot: MMC0

BuildInfo:
- SCFW ba76011e, SECO-FW e8100a5b, IMX-MKIMAGE 0fcc8296, ATF f1a195b
- U-Boot dub-2019.04-r2.1

flash target is MMC:0
Net: Could not get PHY for FEC0: addr 1
Could not get PHY for FEC0: addr 1
Could not get PHY for FEC1: addr 0
eth-1: ethernet@5b040000Could not get PHY for FEC1: addr 0
, eth-1: ethernet@5b050000
Fastboot: Normal
Hit any key to stop autoboot: 0
** No partition table - mmc 0 **
=> run install_linux_fw_sd
** Reading file would overwrite reserved memory **
=> run install_linux_fw_sd
** Reading file would overwrite reserved memory **
=>
</code>

Has someone encountered such a problem?
asked Jan 19 in Other/Legacy by kprzeb New to the Community (0 points)

Please log in or register to answer this question.

...