Home/Support/Support Forum/End device take 8-10 minute to reconnect after Power cycle or NR command with version 4061

End device take 8-10 minute to reconnect after Power cycle or NR command with version 4061

0 votes
Hi
I was setup system with 8 end devices ( battery power ) sending data to coordinator after every 1 minutes interval.

I observed End devices are taking more than 8-10 minutes to rejoin the network, if power cycle given to coordinator or NR-01 issue from coordinator if i use xbee firmware 4061.

If i down grade xbee with ver 405F ( without change in parameter value) , End device connect immediately to coordinator. say within 1 minutes.

Please suggest any modification require in setting.

Product family : XBP24C
Function set :ZIGBEE TH PRO

End device configuration:
SC - 5
SD - 5
NJ - C8
NW - 3
JV - Enable
SP - 5 sec
SN - 0x10
SM - Cyclic Sleep & pin wake-up [5]
ST - 0X64

Receiver (coordinator)
SC - 5
SD - 5
NJ - FF
NW - 0
JV - Enable
SP - 0x200 (5.120) sec
SN - 0x27
SM - No sleep [0]
ST - 0X01
asked Jan 25 in XBee Programmable Development by Sheetal Kasar New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
Adjust the SO command.
answered Sep 16 by mvut Veteran of the Digi Community (15,413 points)
...