Home/Support/Support Forum/Question about Xbee S3B
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Question about Xbee S3B

0 votes
Hi all,

Along with greeting everyone;

I'm working with NCD.io radios, and I'm trying to put together a sensor network, a repeater, and a gateway. It should be noted that all sensors have a sleep mode and every 10 minutes they wake up to send a message. The repeater and the gateway are always powered.

My problem is that the sensors (which have an Xbee S3B radio), when I try to communicate with the gateway through the repeater, sometimes try to connect directly with the gateway and I lose data packets, even worsening the signal.

My question is if there is any way to configure in XCTU, so that the sensors connect by themselves with the repeater and then, this is in charge of sending the message to the gateway.

Thanks in advance.

asked Feb 10 in Device Manager by Fsaavedra New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
No, there is no way to do that. This is a true mesh system where the sleeping node will try to send direct if it is possible.
answered Feb 10 by mvut Veteran of the Digi Community (15,223 points)