Home/Support/Support Forum/Zigbee MODEM does not work correctly after exiting command mode

Zigbee MODEM does not work correctly after exiting command mode

0 votes
NOTE: I believe I found the problem.

We can ignore this question.

I am able to put the Zigbee Pro MODEM into command mode and configure it correctly. But then I exit command mode the MODEM does not respond correctly. How do I make sure the MODEM is ready for normal operation after I exit the command mode?
asked Feb 17 in ZigBee PRO Featureset (and legacy ZNet 2.5) by tschmitz New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I am not sure I understand your question. If the device is properly configured, it will associate with the parent router or coordinator that is allowing Joining.
answered Feb 18 by mvut Veteran of the Digi Community (15,156 points)
...