Home/Support/Support Forum/how check data transfer from coordinate to the end device via repeater in xbee XCTU software ?

how check data transfer from coordinate to the end device via repeater in xbee XCTU software ?

0 votes
asked Sep 14 in XBee3 DigiMesh by bhagirath shelar New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
If the End Device is joined to the repeater, then doing a Node Discovery is one way. Another way is to run a range test from the Coordinator to the End device.
answered Sep 15 by mvut Veteran of the Digi Community (15,413 points)
...