Home/Support/Support Forum/Recent questions tagged s2c
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.
Ask a question:

Recent questions tagged s2c

0 votes
0 answers
Xbee Zigbee througput very low
asked Jun 5, 2018 in ZigBee PRO Featureset (and legacy ZNet 2.5) by YFrickx New to the Community (0 points)
0 votes
0 answers
direct input/output from xbee s2c
asked May 30, 2018 in IEEE 802.15.4 by pradeepk13 New to the Community (0 points)
0 votes
2 answers
Trying to use xctu to update firmware for S2C, didn't work
asked Apr 17, 2018 in XCTU by Kirk Clendinning New to the Community (4 points)
0 votes
0 answers
S2C very low range
asked Mar 12, 2018 in RF Solutions and XBee by relash New to the Community (4 points)
0 votes
0 answers
Xbee s2c read ADC wrong values
asked Mar 5, 2018 in RF Solutions and XBee by sruedat New to the Community (6 points)
0 votes
0 answers
My Xbee s2c is not showing in XTCU when I connect it to windows 10 laptop
asked Mar 2, 2018 in RF Solutions and XBee by DARKARROW New to the Community (0 points)
0 votes
0 answers
Xbee S2C pro is not able to connect with Mighty Gecko (EFR32MG) 2.4 GHz 19.5 dBm
asked Feb 23, 2018 in ZNet 2.5 by vishal kaneriya New to the Community (0 points)
0 votes
2 answers
Xbee network allow on certain devices to join
asked Feb 5, 2018 in ZigBee PRO Featureset (and legacy ZNet 2.5) by Steve Wiggins New to the Community (1 point)
0 votes
1 answer
Commercial shields to interface XBee S2c with Arduino Uno rev. 3
asked Jan 25, 2018 in RF Solutions and XBee by Ferpi New to the Community (0 points)
0 votes
1 answer
Replace a Coordinator under 802.15.4 network
asked Jan 25, 2018 in Multipoint Proprietary by wengineer New to the Community (0 points)
0 votes
1 answer
How to make end device always be in a wake up state
asked Dec 22, 2017 in Multipoint Proprietary by Amar Reddy New to the Community (0 points)
0 votes
1 answer
How many end devices could I connect to one co-ordinator
asked Nov 30, 2017 in RF Solutions and XBee by Amar Reddy New to the Community (0 points)
0 votes
2 answers
Low power mesh with Digimesh S2C modules
asked Nov 7, 2017 in DigiMesh Proprietary Mesh Networking by PierreRF New to the Community (1 point)
0 votes
2 answers
Is it necessary to connect Vref pin somewhere using XBee Series 2?
asked Nov 7, 2017 in Miscellaneous Hardware and Software by Jserra New to the Community (1 point)
Page:
...