Home/Support/Support Forum/Recent questions tagged s2c
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.
Ask a question:

Recent questions tagged s2c

0 votes
1 answer
How to make end device always be in a wake up state
asked Dec 22, 2017 in Multipoint Proprietary by Amar Reddy New to the Community (0 points)
0 votes
1 answer
How many end devices could I connect to one co-ordinator
asked Nov 30, 2017 in RF Solutions and XBee by Amar Reddy New to the Community (0 points)
0 votes
2 answers
Low power mesh with Digimesh S2C modules
asked Nov 7, 2017 in DigiMesh Proprietary Mesh Networking by PierreRF New to the Community (1 point)
0 votes
2 answers
Is it necessary to connect Vref pin somewhere using XBee Series 2?
asked Nov 7, 2017 in Miscellaneous Hardware and Software by Jserra New to the Community (1 point)
0 votes
1 answer
Lost data when de-asserting RTS during receive
asked Oct 20, 2017 in RF Solutions and XBee by CHSH New to the Community (12 points)
0 votes
1 answer
Xbee S3B CTS pin stays high
asked Oct 20, 2017 in RF Solutions and XBee by Jerome New to the Community (5 points)
0 votes
1 answer
Programmable S2C : ADC not accurate
asked Oct 9, 2017 in RF Solutions and XBee by Mark Kestens New to the Community (0 points)
0 votes
1 answer
migratability to digiMesh in S2C
asked Sep 20, 2017 in Plug N' Play by the0nkar New to the Community (0 points)
0 votes
1 answer
How the Three Xbee Communicate in Transparent Mode/AT
asked Sep 19, 2017 in DigiMesh Proprietary Mesh Networking by Ali Gul New to the Community (0 points)
0 votes
1 answer
Match Descriptor Response for HA
asked Aug 8, 2017 in ZigBee PRO Featureset (and legacy ZNet 2.5) by Itumeleng New to the Community (3 points)
0 votes
1 answer
XBEE S2C module looses its network
asked Jul 27, 2017 in IEEE 802.15.4 by Sheetal Kasar New to the Community (3 points)
0 votes
1 answer
wireless communication loss in S2C module
asked Jul 27, 2017 in IEEE 802.15.4 by Sheetal Kasar New to the Community (3 points)
0 votes
1 answer
2 xbee sending info to coordinator - setup
asked Jul 18, 2017 in RF Solutions and XBee by HRITHU O A New to the Community (5 points)
0 votes
1 answer
SPI AT Command frame always causes a Modem Status reply
asked Jun 29, 2017 in IEEE 802.15.4 by ecarusi New to the Community (1 point)
Page:
...