Knowledge Base

What would you like to know?

XStream product manual https://www.digi.com/support/knowledge-base/xstream-product-manual Jul 06, 2017
Use this document to compare Digi legacy XStream radio modems. (A simple Digi International range test can be performed in ~15 minutes.)Relevant FilesDigi specifications / features review https://www.digi.com/support/knowledge-base/digi-international-xstream-specifications-comparis Jul 06, 2017
https://www.digi.com/support/knowledge-base/drawing-dimensions-for Jul 06, 2017
To determine whether you should use 900 MHz or 2.4 GHz RFd2d technology for your products you need to answer the following: What is the maximum range your product needs to communicate? Will y... https://www.digi.com/support/knowledge-base/application-note-900-mhz-vs-2-4-ghz-in-xstream-rad Jul 06, 2017
The predicted Mean Time Between Failure of the 9XStream module is 700,000 hours. This is a computed prediction, not a field tested result. The computation takes into account the life expectancy of ... https://www.digi.com/support/knowledge-base/what-is-the-mean-time-between-failure-mtbf-for-the Jul 06, 2017
The document attached below explains how to use Digi@s Module Address and Module Address Mask to set up global or local addresses for establishing module groups, subnets, etc. It includes exampl... https://www.digi.com/support/knowledge-base/xstream-module-addresses-and-masks Jul 06, 2017
This document discusses the measurement of received RF signals and how these measurements are read and reported. It includes tables showing how the RS values returned from the ATRS command corre... https://www.digi.com/support/knowledge-base/received-signal-strength-indicator-rssi-on-xstream Jul 06, 2017
XCite and XStreamThere are three different sleep (power down) modes available on XCite and XStream modems, listed here in order of efficiency:1. (most efficient) Pin Sleep - allows the modem to be ... https://www.digi.com/support/knowledge-base/sleep-modes-on-xcite-xstream-and-xtend Jul 06, 2017
What are the differences between the 9XStream and the 9XCite modules? Here is a brief table highlighting the differences: 9XCite 9XStream Output power 1mW 100mW Input vol... https://www.digi.com/support/knowledge-base/9xstream-vs-9xcite Jul 06, 2017
There were some significant changes in functionality of the XStream firmware from version 4.25 to 4.29. Here are some of the changes that might affect compatibility:ChangeBenefitTime to execute ATW... https://www.digi.com/support/knowledge-base/compatibility-from-xstream-firmware-version-4-25-t Jul 06, 2017
83 result(s) for 24XStream