x

Knowledge Base

What would you like to know?

HOW TO: Access the Web Interface on the Digi ConnectPort X2e Smart Energy gateways By pressing the small reset button on the top of the unit, the web interface will be made temporarily available... https://www.digi.com/support/knowledge-base/how-to-access-the-web-interface-on-the-digi-connec Jul 06, 2017
History:ConnectPort CP-X2e gateways with Gateway firmware version3.0.6.x (CP-X2e SE) or3.0.7.x (CP-X2e ZB) and earlier have a known issue trying to re-connect to Device Cloud after a Device Cloud ... https://www.digi.com/support/knowledge-base/connectport-x2e-zb-or-connectport-x2e-for-smart-en Jul 06, 2017
What is the Maximum RF Range for the ConnectPort X2e Smart Energy Gateways?The ConnectPort X2e Smart Energy gateway RF distance information can be found in the following specifications page under t... https://www.digi.com/support/knowledge-base/what-is-the-maximum-rf-range-for-the-connectport-x Jul 06, 2017
Introduction: The following article discusses the ability of the ConnectPort X2 or X2e for Smart Energy Router gateway to leave a Smart Energy network. @leave_network@ is one of the commands avail... https://www.digi.com/support/knowledge-base/how-to-force-a-digi-connectport-x2-or-x2e-smart-en Jul 06, 2017
Is it possible to SSH to a ConnectPort X2e Smart Energy Gateway for access to the command line interface? Due to enhanced security with Smart Energy gateways, it is not possible to access the co... https://www.digi.com/support/knowledge-base/is-it-possible-to-ssh-to-a-connectport-x2e-smart-e Jul 06, 2017
Cannot Access the Command Line on a Digi ConnectPort X2e Smart Energy GatewayThese Smart Energy gateways do not have local command line access. Minimal configuration, such as assigning a static IP... https://www.digi.com/support/knowledge-base/cannot-access-the-command-line-on-a-digi-connectpo Jul 06, 2017
Introduction Digi uses two different Time Server (NTP) factory default configurations on ConnectPort X2e for Smart Energy and XBee Gateway ZB products: A configuration for cellular-connected ga... https://www.digi.com/support/knowledge-base/recommended-time-server-ntp-configuration-for-conn Jul 06, 2017
It is recommended the proper model is purchased as the conversion of these particular Smart Energy gateway models@is not supported (only the ConnectPort X2e SE models support a role change as it ha... https://www.digi.com/support/knowledge-base/can-i-convert-my-connectport-x2-smart-energy-gatew Jul 06, 2017
ConnectPort X2e SE (Smart Energy) TroubleshootingDigi Device CloudBy default, gateways point to the http://devicecloud.digi.comproduction server (some older gateways may point to my.idigi.com). Fo... https://www.digi.com/support/knowledge-base/connectport-x2e-se-smart-energy-troubleshooting Jul 06, 2017
ConnectPort X2e for Smart Energy (Router) InstallationFor Digi ConnectPort X2e Smart Energy gateway deployments, you will want to ensure that there is a networking infrastructure in place that will... https://www.digi.com/support/knowledge-base/connectport-x2e-for-smart-energy-router-installati Jul 06, 2017
32 result(s) for ConnectPort+X2e+Smart+Energy