x

Knowledge Base

What would you like to know?

Common connector types used in RF communication.Digi RF modems commonly use RP-SMA and RP-TNC connector types. Typical RF modules use RP-SMA, U.FL, MMCX.Outdoor connectors commonly used on antenna... https://www.digi.com/support/knowledge-base/rf-connector-identification-chart Jul 06, 2017
vehicle codes for the ODB connector in cars and trucks can usually be found in the vehicles manual. Please check with them. https://www.digi.com/support/knowledge-base/wva-vehicle-codes-for-odb-connector Jul 06, 2017
Pinout of the Portserver II 16 Power connector are as follows: 1 -- COM2 -- GND3 -- +5v4 -- -12v5 -- +12v https://www.digi.com/support/knowledge-base/pinout-for-portserver-ii-16-power-supply-connector Jul 06, 2017
If Makefile build for Digi Cloud Connector for ANSI C is giving the following error'/usr/bin/ld: cannot find -lz'it means zlib1g-dev package is missing in your linux installation.execute sudo apt-g... https://www.digi.com/support/knowledge-base/digi-cloud-connector-sample-application-fails-to-b Jul 06, 2017
The MMCX female connector used on Digi RF products (XStream and XCite) is an Amphenol part number: 908-22101 You can download datasheets and specifications here. Click on @Customer Drawing@ for... https://www.digi.com/support/knowledge-base/datasheet-for-mmcx-connector-used-on-radio-modules Jul 06, 2017
Digi uses a 2.1mm ID / 5.5mm OD female barrel power connector plug with center positive to connect power to all interface boards and PKG products. These plugs are very common and readily available ... https://www.digi.com/support/knowledge-base/part-number-for-the-barrel-type-power-connector Jul 06, 2017
Digi@s XStream and XCite radio modems are available with an MMCX connector oriented facing directly out of the plane of the board. The pads for additional orientations are on the circuit board, h... https://www.digi.com/support/knowledge-base/how-to-orient-the-mmcx-connector-in-a-different-di Jul 06, 2017
The external battery connector on the Grove XBee Interface board is not fully functional. The FTDI chip is not powered via the external battery connector, and thus acts as a ground, so any XBee pin... https://www.digi.com/support/knowledge-base/grove-xbee-interface-board-battery-connector Nov 22, 2019
In some situations it is necessary to interface the RS232 or RS485 signals to RJ45, terminal strips or other physical connections. The Digi radio modem has the RS232 and RS485/422 signals available... https://www.digi.com/support/knowledge-base/using-an-rj45-adapter-to-connect-to-a-db9-connecto Jul 06, 2017
Serial Cable Pin Outs for DIN Connector on HP9000 Servers DIN connector front view 2 1 4 __ 3 6 || 5 ^ | | KEY DIN Conne... https://www.digi.com/support/knowledge-base/serial-cable-pin-outs-for-din-connector-on-hp9000 Jul 06, 2017
80 result(s) for Connector