x

Knowledge Base

What would you like to know?

Log File Size--Local Memory:When storing log files to the DigiCM local memory, a total of 3.5Meg is available. The amount of memory available per serial port is dependent on the port count of the D... https://www.digi.com/support/knowledge-base/what-is-the-maximum-log-file-sizes-when-storing-to Jul 06, 2017
Default size of Inbound and Outbound Message Queue is 64KOne SCO message of Digi M10 can have size atmost 1024 bytes, wherein ORBCOMM supports upto 8192 bytesGlobalGram and reports size are same as... https://www.digi.com/support/knowledge-base/digi-m10-inbound-outbound-queues-and-message-size Jul 06, 2017
You might be using old version of Dashboard and you have an old firmware on M10. Use C:\Program Files\Digi\Digi m10 JumpStart Kit\tools\m10UpgradeUtility.exe tool in your PC to upgrade modem f... https://www.digi.com/support/knowledge-base/m10-is-connected-but-s-n-version-numbers-are-not-f Jul 06, 2017
You are getting this mesage because a system command from ORBCOMM satellite has disabled your M10.To enable your Transmitter you need to have a valid subscription from ORBCOMM.For Digi M10 JSK cust... https://www.digi.com/support/knowledge-base/how-to-get-rid-of-transmitter-disabled-message-fla Jul 06, 2017
HID (Human Interface Device) style devices and USB hubs are compatible with all model ConnectPort Displays. Devices that typically fall into the HID category are simple input devices such as USB ... https://www.digi.com/support/knowledge-base/what-kinds-of-usb-devices-are-compatible-with-the Jul 06, 2017
1. If you look at the front panel of the unit, the System Status LED should blink slow Green and the two USB port LEDs should be solid Green. You should see this behavior after the unit has booted,... https://www.digi.com/support/knowledge-base/general-troubleshooting-tips-for-the-connectport-d Jul 06, 2017
Why we need to turn on/off M10?M10 take less than 1 minute to get a satellite link. It all depends upon the availability of the satellite at that particular time. M10 scans through different freque... https://www.digi.com/support/knowledge-base/how-do-i-turn-m10-on-off-based-on-satellite-availa Jul 06, 2017
When should I choose to use a CAT M module over a CAT 1 module?Both use the same LTE network.@ The main difference is that CAT M is designed for devices that communicate sporadically or occasionall... https://www.digi.com/support/knowledge-base/which-xbee-cellular-should-i-choose Aug 13, 2018
The Digi m10 Satellite Modem can be incorporated in Select Solder or Wave Solder processes. Select Solder – No specific fixtures are needed, cycle time slower than wave solder Wave Solder - No-c... https://www.digi.com/support/knowledge-base/digi-m10-soldering-guidance Jul 06, 2017
Using the addp binary on your Linux host, ensure there are executable permissions (chmod a+x addp).@Here are some examples on its usage:@Assign IP address, subnet mask and gateway:@./addp -S -m 00:... https://www.digi.com/support/knowledge-base/linux-addp-command-examples Jul 06, 2017
100 result(s) for Digi+m200