Upcoming Webinar: Robust Solutions for Connected Systems in Buildings x
COVID-19 Digi Technical Support Response x

Knowledge Base

What would you like to know?

The PortServer II will go to PE during the normal boot process. @This is the last step before starting the Operating System.If the PortServer II hangs at PE and never continues to AC, then there is... https://www.digi.com/support/knowledge-base/portserver-ii-hangs-at-pe-and-never-finishes-booti Jul 06, 2017
Log into the PortServer II and issue the following command:set con ramsize=show https://www.digi.com/support/knowledge-base/how-to-determine-the-installed-ram-size-in-a-ports Jul 06, 2017
Pinout of the Portserver II 16 Power connector are as follows: 1 -- COM2 -- GND3 -- +5v4 -- -12v5 -- +12v https://www.digi.com/support/knowledge-base/pinout-for-portserver-ii-16-power-supply-connector Jul 06, 2017
The @set auth@ command does not properly control access to the ports by IP addresses in PortServer II firmware versions 3.1.5, 3.1.9, 3.1.10, and 3.1.11. To get the proper access control via IP ad... https://www.digi.com/support/knowledge-base/the-set-auth-ability-on-the-portserver-ii-doesn-t Jul 06, 2017
@ Use this procedure to reset the PortServer or PortServer II configuration to factory defaults.Important:@You will lose all PortServer configuration settings when you reset your PortServer ... https://www.digi.com/support/knowledge-base/resetting-a-portserver-ii-configuration-to-factory Jul 06, 2017
Log into the PortServer as root, using either telnet or through the serial interface. @Issue the set config command. @The first line of the display will show the version of the firmware running... https://www.digi.com/support/knowledge-base/how-to-determine-firmware-version-level-on-portser Jul 06, 2017
The PortServer II/TS models can support up to four telnet sessions per port by default. This value can be increased, the following example shows how to increase the sessions to five: set port rang... https://www.digi.com/support/knowledge-base/configuring-and-using-multiple-sessions-on-portser Jul 06, 2017
Before you get started:@1. If you've already changed a number of settings and the Portserver II is currently in an unknown state, we recommend a factory default of the unit before continuing with t... https://www.digi.com/support/knowledge-base/how-to-configure-the-portserver-ii-for-a-ppp-conne Jul 06, 2017
Symptom: I am trying to connect a modem to my PortServer product with the RJ45-DB25 cable that came with the PortServer or PortServer II, and it is not working. @@Cause:The RJ45-DB25 cable ship... https://www.digi.com/support/knowledge-base/i-am-trying-to-connect-a-modem-to-my-portserver-pr Jul 06, 2017
Symptom:PortServer II hangs on boot with "b" on the display.Cause:The PortServer is set to use a TFTP host and the IP of the TFTP host is wrong.The file name or location of the TFTP boot file is wr... https://www.digi.com/support/knowledge-base/portserver-ii-hangs-on-boot-with-b-on-the-display Jul 06, 2017
41 result(s) for PortServer+II