Configure the first two devices in Transparent mode
To transmit data wirelessly between your XBee devices, configure them to be in the same network.
Tip To locate a device, select it in XCTU and click the Read radio settings button . The Rx and Tx LED lights on its development board blink green and yellow.
Set up the first XBee device (XBEE_A)
- Select the first XBee device.
- Click the Load default firmware settings button .
Tip In the following steps, type parameter letters in the Search box to quickly find a parameter.
-
Configure the following parameters:
ID: 2015
DH: 0013A200
DL: SL of XBEE_B (Enter the last eight characters of the MAC address for XBEE_B. Or select XBEE_B and find its SL value.)
NI: XBEE_A - Click the Write radio settings button .
Set up the second XBee device (XBEE_B)
- Configure the following parameters:
ID: 2015
DH: 0013A200
DL: SL of XBEE_A (Enter the last eight characters of the MAC address for XBEE_A. Or select XBEE_A and find its SL value.)
NI: XBEE_B
- Click the Write radio settings button .
After you write the radio settings for the XBee devices, their names appear in the Radio Modules area.
For more information about the parameters, see the following table:
Parameter | XBEE_A | XBEE_B | Effect |
---|---|---|---|
ID | 2015 | 2015 | Defines the network that a device will attach to. This must be the same for all devices in your network. |
DH | 0013A200 | 0013A200 | Defines the destination address (high part) for the message. |
DL | SL of XBEE_B | SL of XBEE_A |
Defines the destination address (low part) for the message. The value of this setting is the Serial Number Low (SL) of the other XBee device. |
NI | XBEE_A | XBEE_B |
Defines the node identifier. Note The default NI value is a blank space. Delete the space when you change the value. |