Send a sequence of packets

After you have added at least two data packets to the Send packets area, you can send a sequence of data packets to a radio module running in AT mode. The sequence is defined by the list of packets to send and the send sequence options located next to the list. For instructions on adding packets, see Add a data packet.

  1. In the Send sequence dialog of the AT Console, configure the following options:
    • Transmit interval: Specify the amount of time, in milliseconds, to pause between frames. The minimum value is 0ms and the maximum value is 60000ms (1 minute).
    • Repeat times: Select this option to specify the number of times the sequence should be repeated or sent. By default, this value is 1.
    • Loop infinitely: Select this option to send the sequence of frames in an infinite loop.

  2. Click Start sequence. The sent and received data appear in the Data traffic monitor.

  3. The process can end by itself. You can also click Stop sequence at any time to halt transmission.

    4. For more information, see Send a single packet.