The wireless variant of the ConnectCore 6UL SOM integrates the Qualcomm QCA6564 wireless chipset with the following features:

  • Dual Band 5GHz 802.11ac or 2.4/5GHz 802.11n Wireless Local Area Network (WLAN)

    • 20/40 MHz at 2.4GHz

    • 20/40/80 MHz at 5GHz

  • Authentications support as defined in 802.11i:

    • Open

    • WPA (Wi-Fi Protected Access)

    • WPA2 personal and enterprise

    • WPA3 personal and enterprise with 128-bit encryption suite (192-bit encryption not supported)

  • Data encryption using Advanced Encryption Standard (AES) or Temporal Key Integrity Protocol (TKIP)

  • Country and regulatory domain configuration as defined in 802.11d

  • Fast BSS Transition as defined in 802.11r (Fast Roaming)

  • Dynamic Frequency Selection (DFS) support on 5GHz networks as defined in 802.11h

  • Cisco Compatible Extensions (CCX)

  • Station, SoftAP and Wi-Fi Direct (P2P) concurrent modes

  • IBSS/Adhoc mode is not supported, use Wi-Fi Direct instead

  • Bluetooth 5.0, ANT+, backward-compatible

  • Bluetooth and WLAN coexistence

Digi Embedded Yocto defines the dey-wireless feature that builds the following packages for working with the Wi-Fi interface:

  • wpa-supplicant: The WPA supplicant is the IEEE 802.1X/WPA component that is used in the client stations

  • hostapd: An IEEE 802.11 access point and IEEE 802.1X/WPA/WPA2/EAP/RADIUS authenticator

  • crda: The Central Regulatory Domain Agent (CRDA) acts as the udev helper for communication between the kernel and user space for regulatory compliance

  • iw: A nl80211-based CLI configuration utility for Wi-Fi devices

  • NetworkManager: Daemon to manage any station network interfaces.


See the following topics for more information on working with the wireless interface:

Disabling Wi-Fi

Wi-Fi is enabled by default on the ConnectCore 6UL variants that support it. To disable Wi-Fi, add the following lines to your platform device tree:

/* Disable Wi-Fi */
/delete-node/ &{/wireless};
&usdhc1 {
	/* Drive WL_EN low to disable Wi-Fi */
	pinctrl-assert-gpios = <&gpio5 0 GPIO_ACTIVE_LOW>;

This patch:

  • deletes the wireless node of the device tree. The existence of this node triggers the initialization scripts that bring up the Wi-Fi interface, so these won’t start when the node is missing.

  • makes use of the uSDHC1 node (connected to the Wi-Fi chip), to drive the WL_EN line low, thus disabling the Wi-Fi chip.

Expect a harmless error message in U-Boot reporting that it couldn’t find the wireless node to fill in its MAC address.

Even if you disable Wi-Fi, you won’t be able to make use of the uSDHC1 interface to connect to other peripherals because it is connected internally to the Wi-Fi chip. To do so, you need a variant without a Wi-Fi chip.