The ConnectCore 8X SBC Pro assembles an XBee socket that allows you to connect a through-hole XBee module.
|See the ConnectCore 8X SBC Pro Hardware Reference Manual for the XBee socket pin-out description.|
On the ConnectCore 8X SBC Pro:
The XBee module is connected through two interfaces:
MCA_UART2 of the MCA. MCA_UART2 is configured (4-wires) and enabled on the default ConnectCore 8X SBC Pro device tree.
The following XBee lines are connected to MCA GPIOs:
XBEE_RESET: Connected to MCA_IO15
XBEE_SLEEP_RQ: Connected to MCA_IO11
XBEE_ON/SLEEP_N: Connected to MCA_IO16
The XBee does not require a specific driver.
Device tree bindings and customization
The XBee does not have specific device tree bindings. If using GPIOs of the CPU for controlling some XBee lines (RESET_N, SLEEP_RQ…) you can configure the pinctrl for these as part of the UART node that’s connected to the XBee socket.
Using the XBee interface
The XBee Manager Sample Application demonstrates the usage of the XBee Java API in Android by giving an example of all the available options using a local XBee device attached to the SBC board. This example uses the Serial APIX for the communication with the attached XBee.
See Serial API for more information about the Serial APIx.
Go to GitHub to see the application instructions and source code.
See Cellular for additional information on the use of XBee cellular devices.