Follow these steps to set up your ConnectCore MP15 Development Kit hardware:
Run serial console setup script
|You only need to complete this step if you are running Linux. If so, you may need to install a driver for the serial interface of the ConnectCore MP15 Development Kit.
Download the script for the USB-to-serial driver.
Give execution permission to the file in your PC and run it as administrator.
$ chmod +x install_usb_driver.sh $ sudo ./install_usb_driver.sh Installing Cypress USB driver. Rule "/etc/udev/rules.d/90-cyusb.rules" doesn't exist, creating a new one. File "/etc/modprobe.d/blacklist.conf" exists, checking if the rule is already there. Rule for cytherm not found. Adding cytherm to the blacklist. Please plug/unplug your usb device to be recognized.
Connect the hardware
Connect the microAB USB cable to the USB CONSOLE connector on the board and to your host computer. The operating system will detect the board as a new serial port. Identify the new serial port on your operating system (
COMxin Windows), as you will need to open a console at that port in the following step.
Connect the Ethernet cable (not included) to the Ethernet port.
(Optional) Connect an HDMI cable (not included) to the HDMI connector and then to an HDMI-compatible display.
Make sure the BOOT micro-switches are all in the OFF position.
Connect the power supply to the power barrel connector.