Set up the software to create Qt applications for your target.
|Before starting development for your ConnectCore platform, make sure your device is correctly connected, powered, and running. See Step 2 - Set up the hardware and Step 3 - Program the Yocto firmware.|
Install Qt Creator
Before installing Qt Creator, check the Qt Creator Supported Platforms documentation to make sure your system is compatible.
|Qt Creator is available for Windows, Linux, and MacOS. This documentation covers Linux installation instructions only.|
Follow the steps below to download and install Qt Creator on your computer.
Visit https://download.qt.io/official_releases/qtcreator/ and download the latest release for Linux.
After the package is downloaded, give it execution permissions and launch it:
$ chmod +x qt-creator-opensource-linux-x86_64-X.Y.Z.run $ ./qt-creator-opensource-linux-x86_64-X.Y.Z.run
Follow the on-screen instructions to complete the product installation.
Do not launch Qt Creator at this point.
Install Digi Embedded Yocto toolchain with Qt support
To install a Digi Embedded Yocto toolchain you need a development machine with at least:
Linux 64-bit system (Ubuntu 18.04)
4 CPU cores
4 GB of RAM
10 GB of free disk space
Digi Embedded Yocto provides a pre-compiled C/C++ toolchain that matches the default image artifact. You can use it to cross-compile applications to run on Digi embedded platforms, including graphical GTK or QT5 applications.
To install new Digi Embedded Yocto toolchains in your system, follow these steps:
Download the toolchain installer from the Digi support page. (You can also use your own pre-compiled toolchains.)
$ wget https://ftp1.digi.com/support/digiembeddedyocto/3.2/r3/sdk/ccimx8x-sbc-pro/xwayland/dey-glibc-x86_64-dey-image-qt-xwayland-aarch64-ccimx8x-sbc-pro-toolchain-3.2-r3.sh
Give execution permission to the installer and install the toolchain on your host PC.
$ chmod +x dey-glibc-x86_64-dey-image-qt-xwayland-aarch64-ccimx8x-sbc-pro-toolchain-3.2-r3.sh $ ./dey-glibc-x86_64-dey-image-qt-xwayland-aarch64-ccimx8x-sbc-pro-toolchain-3.2-r3.sh
Start Qt Creator from a configured toolchain shell
|You must execute Qt Creator from a new shell after configuring the toolchain environment.|
To do so, follow these steps:
Open a new shell.
Navigate to the Digi Embedded Yocto toolchain installation folder.
Set up the toolchain environment by sourcing the
$ . environment-setup-aarch64-dey-linux
Navigate to the Qt Creator installation folder
Start Qt Creator by executing the
$ ./qtcreator.sh &