XCite Firmware Revision History

Firmware revision history for the XCite radio modems.

For reference, in the Version revision number x indicates: 1 = 9600 hopping, 2 = 9600 single channel, 3 = 38400 hopping, 4 = 38400 single channel.

Beta

Released

Version 0.x.2.1

January 21, 2006

• Fix - Fixed XC09-038 unable to stream 0x00 in any large quantities.
• Fix - Fixed Modem occasionally staying awake longer than ''''Time to Sleep''''.

Version 0.x.2.0

November 3, 2005

• Fix - Fixed cyclic sleep bug with pin wake up. When waking the modem and sending data the data would not always be sent correctly.
• Fix - Fixed dropping packets when streaming data. This was more sensitive at slower baud rate.

Version 0.x.1.0

March 6, 2005

• Fix - Fixed time to beacon getting reset after leaving command mode. After leaving command mode the first transmission was always sent with a long beacon.

Version 0.x.0.F

October 29, 2004

• Fix - Radio would sometimes go to sleep during long header (preamble).

Version 0.x.0.E

September 4, 2004

• Fix - Pin Sleep mode current pulling extra .1 ma now is 1Ua for micro.
• TX/PWR has been fixed to pulse low towards the end of a TX packet.

Version 0.x.0.D

• Fix - When the receiver hopped to successive channels the pll was not clocked to change channels. This bug could be seen by changing the hop channel to either 1,4 or 5 and sending very large packets (5000 bytes).
• Note: This version is for hopping code only.

Version C.3.0.D

• Added ATR0 as non-at settable command. This works similar to the XStream.
• Added ATWK as non-AT settable command. This command controls the amount of time the module is awake during cyclic sleep mode.

Version 0.x.0.B

• Version changed with new hardware version.
• Bug - XC09-038 receiver would miss data when interface rate was set to 4800 baud or less. Fixed in version 0C.
• Bug - Hopping modules would miss data when ATHP was set above 1. Fixed in version 0C.