This KB article is intended to give users an understanding of how much data the Digi Remote Manager (Digi RM) connecton/client typically uses, for Digi products that run the modern DAL Operating System.
Average monthly data usage:
- 4.68MB on cellular connections
- 18.1 MB on non-cellular connections (wired Ethernet, Wi-Fi client, PPPoE, etc)
- No configuration/firmware updates
- Digi RM-related configuration settings at their defaults
- Connection to Digi RM enabled
- Keep-alives set to 290-seconds for cellular, 60-seconds for non-cellular
- Health metrics set to once per hour
- Device event logging disabled
Maximum monthly data usage: 263MB
- One configuration update with 50 config settings (approximately 10kB in size)
- One firmware update included (approximately 30 MB as the average DAL product firmware size, some platforms have smaller firmware some have larger)
- All Digi RM-related config settings enabled and tuned to their most-often frequency
- Initial connection sequence to Digi RM along with query_state and query_setting RCI calls from Digi RM - 12.25kB
- Device event logging enabled at 1/minute intervals - 137 MB per month
- Keep-alives set to once per 30-seconds - 34 MB per month
- Health metrics reported once per minute - 62.64MB per month
Minimum monthly data usage: 154 kB
- No configuration/firmware updates
- Only critical Digi RM-related configuration settings enabled to maintain a base connectivity to Digi RM
- Initial connection sequence to Digi RM along with query_state and query_setting RCI calls from Digi RM - 12.25kB
- Keep-alives set to once per 2 hours - 141.84 kB
- Device event logging disabled
- Health metrics disabled
Last updated:
Jan 01, 2024