Support / Knowledge Base / Escape Character doesn't close Telnet Session

Escape Character doesn't close Telnet Session

Symptom:

After doing a telnet to a port on the PortServer device and then using the escape character ^] to exit the session, the session is still active .

 

Cause:

If you use the escape character ^] and press enter, this will only back you out of the session, but not close the session.

 

Solution:

To completely back out and close the session use the escape character ^] followed by a period, rather than the enter key.
Last updated: Aug 23, 2017

Filed Under

Network

Recently Viewed Articles

No recently viewed articles
Contact a Digi expert and get started today! Contact Us