How to Create a SSL Tunnel Between Two PortServer TS Units

The following example shows the configuration of an SSL bridge  using port 4 on two PortServer TS units.

To setup an encrypted serial tunnel using SSL between two PortServer TS units, first browse to the web interface of one unit that would be initiating the connection.  Select:


Config-> Serial ports-> 4 -> Set the Port profile=TCP Sockets

Config-> Serial ports-> 4 -> TCP Client 

Specify: Connect=always
Enter the IP address of the other PortServer TS
Specify: Service=ssl
Enter: TCP Port=2604

On the other PortServer TS (receiving end):

Config->Serial ports->"4"->  Port profile=Printer

Last updated: May 15, 2019

Filed Under


Recently Viewed

No recently viewed articles

Did you find this article helpful?