You are viewing an article about an obsolete product. Information on this page is provided as-is and not supported.

How to use a Digi TransPort as an SSH Client from the Command Line

The command implemented to use the SSH client is : sshc

When logged in on the Digi TransPort, a typical command would be in the form :

sshc <username>@<hostname>

It is possible to specifify a protocol version priority if the user wish to using the following command line argument :

-ssh1: use V1 only
-ssh2: use V2 only
-ssh12: prefer V1
-ssh21: prefer v2

It is also possible to configure the SSH client using the sshcli command.
 

ss123456>sshcli 0 ?
Parameters are..
conn_to: 10
hostsfile: known_hosts
idfile: privid
idrsafile: privid_rsa
idrsafile1: privid_rsa1
comp: 0
svraliveint: 0
svralivemax: 3
pubkeyauth: ON
pwdauth: ON
enc3descbc: 2
encaes128cbc: 1
encaes192cbc: 1
encaes256cbc: 1
macmd5: 2
macmd596: 2
macsha1: 1
macsha196: 1
debug: 0
OK

For example, to SSH into another Digi TransPort that would be using IP address of 192.168.1.22 with default username and password :

sshc username@192.168.1.22

 

ss123456>sshc username@192.168.1.22

The authenticity of host '192.168.1.22 (192.168.1.22)' can't be established. RSA key fingerprint is e3:25:dd:bf:1a:03:05:1c:1c:0c:18:31:1e:1c:e2:b0.
Are you sure you want to continue connecting (yes/no)? yes

username@192.168.1.22's password:xxxxxxx

SN:789012
Welcome. Your access level is SUPER

ss789012>
*note that the serial number has changed to the second unit

 

To leave the session and go back to the previous router's cli, just issue exit :

ss789012>exit
OK

ss789012>
ss123456>

Last updated: Jan 09, 2024

Filed Under

Cellular/Transport

Recently Viewed

No recently viewed articles

Did you find this article helpful?