Zigbee Home Automation

When developing a Zigbee Home Automation application or Wanting to talk with a Zigbee Home Automation Device, the XBee module you should select is the XBee ZB SMT module or XBee ZB (Zigbee) Surface Mount module.

Using our XCTU software or some other Terminal Emulator or processor, the following settings within the XBee ZB SMT module would need to be set:

    ZS 2
    AP 1
    AO 3
    EE 1
    EO 2
    KY 0x5A6967426565416C6C69616E63653039

Remember to make sure that you use the WR command to write these parameters to the radios non-volatile memory.

Last updated: Aug 23, 2017

Recently Viewed

No recently viewed articles

Did you find this article helpful?